Install paclink-unix
- Configure a single MTA
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
plu:install_plu [2017/09/29 11:15] gunn [After install need to do some config] |
plu:install_plu [2021/10/01 12:06] (current) gunn [On Debian bullseye] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Check out, build & install paclink-unix ====== | ====== Check out, build & install paclink-unix ====== | ||
* [[https://groups.yahoo.com/neo/groups/paclink-unix/conversations/topics/331 | setup for getting paclink-unix working on Ubuntu]] - from paclink-unix forum on Yahoo. | * [[https://groups.yahoo.com/neo/groups/paclink-unix/conversations/topics/331 | setup for getting paclink-unix working on Ubuntu]] - from paclink-unix forum on Yahoo. | ||
+ | * These instructions are old & use the un-maintained code from SourceForge. Keep reading to see how to get the latest code from the github repository. | ||
===== Get current source code for paclink-unix ===== | ===== Get current source code for paclink-unix ===== | ||
* To get a copy of the current repository use [[https://github.com/nwdigitalradio/paclink-unix | this link]]: | * To get a copy of the current repository use [[https://github.com/nwdigitalradio/paclink-unix | this link]]: | ||
Line 19: | Line 20: | ||
* postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | * postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | ||
- | ==== On debian (6.x) Squeeze ==== | + | ==== On Debian (6.x) Squeeze ==== |
* Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
Line 26: | Line 27: | ||
</code> | </code> | ||
- | ==== On debian (7.x) Wheezy ==== | + | ==== On Debian (7.x) Wheezy ==== |
* Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
Line 39: | Line 40: | ||
</code> | </code> | ||
- | ===== On Raspian Jessie ==== | + | ===== On Raspian Jessie, Stretch or Buster ==== |
* Note that the RPi Raspian install is identical to Debian Jessie | * Note that the RPi Raspian install is identical to Debian Jessie | ||
+ | <code bash> | ||
+ | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | ||
+ | </code> | ||
+ | |||
+ | ===== On Debian bullseye ==== | ||
+ | |||
+ | * Even though libgmime 3.0 is available, use the older libgmime 2.6 until port to 3.0 is complete. | ||
<code bash> | <code bash> | ||
sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev |