Install paclink-unix
- Configure a single MTA
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
plu:install_plu [2017/12/04 10:15] gunn [On Raspian Jessie] |
plu:install_plu [2021/10/01 12:06] (current) gunn [On Debian bullseye] |
||
---|---|---|---|
Line 20: | Line 20: | ||
* postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | * postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | ||
- | ==== On debian (6.x) Squeeze ==== | + | ==== On Debian (6.x) Squeeze ==== |
* Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
Line 27: | Line 27: | ||
</code> | </code> | ||
- | ==== On debian (7.x) Wheezy ==== | + | ==== On Debian (7.x) Wheezy ==== |
* Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
Line 40: | Line 40: | ||
</code> | </code> | ||
- | ===== On Raspian Jessie or Stretch ==== | + | ===== On Raspian Jessie, Stretch or Buster ==== |
* Note that the RPi Raspian install is identical to Debian Jessie | * Note that the RPi Raspian install is identical to Debian Jessie | ||
+ | <code bash> | ||
+ | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | ||
+ | </code> | ||
+ | |||
+ | ===== On Debian bullseye ==== | ||
+ | |||
+ | * Even though libgmime 3.0 is available, use the older libgmime 2.6 until port to 3.0 is complete. | ||
<code bash> | <code bash> | ||
sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev |