Install paclink-unix
- Configure a single MTA
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
plu:install_ax25 [2017/12/04 10:10] gunn [AX.25] |
plu:install_ax25 [2020/08/02 11:15] (current) gunn [AX.25] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| * [[http://www.febo.com/packet/linux-ax25/index.html | Linux AX.25 Configuration]] - by John Ackermann, N8UR | * [[http://www.febo.com/packet/linux-ax25/index.html | Linux AX.25 Configuration]] - by John Ackermann, N8UR | ||
| * Also check out [[http://www.faqs.org/docs/Linux-HOWTO/AX25-HOWTO.html | Linux Amateur Radio AX.25 HOWTO]] - by Jeff Tranter, VE3ICH | * Also check out [[http://www.faqs.org/docs/Linux-HOWTO/AX25-HOWTO.html | Linux Amateur Radio AX.25 HOWTO]] - by Jeff Tranter, VE3ICH | ||
| - | * Charles Schumann K4GBB has very good notes on [[http://k4gbb.no-ip.org/docs/myhowto.html | setting up AX.25 & an RMS Gateway]] on the Raspberry PI [[http://k4gbb.no-ip.org/docs/raspberry.html | here]] | + | |
| ====== Install AX.25 library, apps & tools ====== | ====== Install AX.25 library, apps & tools ====== | ||
| * I usually pull the ax25 library from [[https://github.com/ve7fet/linuxax25/tree/master/libax25 | Craig Small VE7FET's github repo]] | * I usually pull the ax25 library from [[https://github.com/ve7fet/linuxax25/tree/master/libax25 | Craig Small VE7FET's github repo]] | ||
| Line 45: | Line 45: | ||
| ====== Configure AX.25 ====== | ====== Configure AX.25 ====== | ||
| + | * [[plu:example_config_files:systemd | example config using systemd]] | ||
| ===== Basic Setup for Config files ===== | ===== Basic Setup for Config files ===== | ||
