Install paclink-unix
- Configure a single MTA
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
plu:install_winlink [2016/04/11 10:55] gunn [Example session] |
plu:install_winlink [2016/04/11 11:04] (current) gunn [Winlink Secure Login] |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| -P --wl2k-passwd Set password for WL2K secure login | -P --wl2k-passwd Set password for WL2K secure login | ||
| </file> | </file> | ||
| + | |||
| + | * **Note:** enabling secure login is a 2 step process. | ||
| + | * You must must first go to the Winlink site & update your Winlink account | ||
| + | * You must either use a command line parameter or the config file entry for wl2k password. | ||
| ===== Example config file entry ====== | ===== Example config file entry ====== | ||
| * The config file exists in /usr/local/etc/wl2k.conf | * The config file exists in /usr/local/etc/wl2k.conf | ||
| Line 22: | Line 26: | ||
| ===== Example session ===== | ===== Example session ===== | ||
| * An example session using wl2ktelnet & sending a Winlink message addressed to myself | * An example session using wl2ktelnet & sending a Winlink message addressed to myself | ||
| + | * Note the 2 consecutive lines containing **;PQ** and **Challenge received:** | ||
| ==== Sending a Message ==== | ==== Sending a Message ==== | ||
