Install paclink-unix
- Configure a single MTA
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
plu:install_exim:ai4ri [2016/04/14 08:34] gunn [Installation Instructions for exim-daemon-heavy by Charles AI4RI] |
plu:install_exim:ai4ri [2016/04/14 08:52] (current) gunn [Pre-installation requirements] |
||
---|---|---|---|
Line 11: | Line 11: | ||
* If you are using the multiple config version of exim-config let me know. | * If you are using the multiple config version of exim-config let me know. | ||
- | * When using Exim, be sure to build paclink-unix with the enable-postfix config: | + | * When using Exim, be sure to [[plu:install_plu#build_paclink-unix | build paclink-unix]] with the enable-postfix config: |
<code bash> | <code bash> | ||
./configure --enable-postfix | ./configure --enable-postfix | ||
</code> | </code> | ||
- | * this enables the correct command line options for the sendmail command. | + | * this enables the correct command line options for the //sendmail// command. |
===== Installation Instructions for exim4 wl2k system filter ===== | ===== Installation Instructions for exim4 wl2k system filter ===== |