Install paclink-unix
- Configure a single MTA
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
plu:install_plu [2017/12/04 10:15] gunn [On Raspian Jessie] |
plu:install_plu [2021/09/28 23:37] gunn [On Raspian Jessie or Stretch] |
||
---|---|---|---|
Line 40: | Line 40: | ||
</code> | </code> | ||
- | ===== On Raspian Jessie or Stretch ==== | + | ===== On Raspian Jessie, Stretch or Buster ==== |
* Note that the RPi Raspian install is identical to Debian Jessie | * Note that the RPi Raspian install is identical to Debian Jessie | ||
<code bash> | <code bash> | ||
sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | ||
+ | </code> | ||
+ | |||
+ | ===== On Debian bullseye ==== | ||
+ | |||
+ | <code bash> | ||
+ | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-3.0-dev | ||
</code> | </code> | ||
===== Build paclink-unix ===== | ===== Build paclink-unix ===== |