Install paclink-unix
- Configure a single MTA
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
plu:install_plu [2017/12/04 10:15] gunn [On Raspian Jessie] |
plu:install_plu [2021/09/28 23:40] gunn [On debian (6.x) Squeeze] |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| * postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | * postfix will prompt for the type of installation you want but for this case the config files are manually edited so your choice is not critical. | ||
| - | ==== On debian (6.x) Squeeze ==== | + | ==== On Debian (6.x) Squeeze ==== |
| * Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
| Line 27: | Line 27: | ||
| </code> | </code> | ||
| - | ==== On debian (7.x) Wheezy ==== | + | ==== On Debian (7.x) Wheezy ==== |
| * Required packages for Debian Squeeze | * Required packages for Debian Squeeze | ||
| Line 40: | Line 40: | ||
| </code> | </code> | ||
| - | ===== On Raspian Jessie or Stretch ==== | + | ===== On Raspian Jessie, Stretch or Buster ==== |
| * Note that the RPi Raspian install is identical to Debian Jessie | * Note that the RPi Raspian install is identical to Debian Jessie | ||
| <code bash> | <code bash> | ||
| sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-2.6-dev | ||
| + | </code> | ||
| + | |||
| + | ===== On Debian bullseye ==== | ||
| + | |||
| + | <code bash> | ||
| + | sudo apt-get install postfix libdb-dev libglib2.0-0 zlib1g-dev libncurses5-dev libdb5.3-dev libgmime-3.0-dev | ||
| </code> | </code> | ||
| ===== Build paclink-unix ===== | ===== Build paclink-unix ===== | ||
